For Toyota Camry 2007 2008 2009 Left/Right Front Headlamp Headlight Lens Cover Transparent Lampshade Clear Car Headlamp Shell

Description

Report Item / Suspicious Activity

For Toyota Camry 2007 2008 2009 Headlight Cover Lens Transparent Lamp Shell Plexiglass Replace Original Lampshade

Features:

-100% Brand New and High Quality

-Made of high quality polycarbonate

-With protective UV coating to prevent yellowing or fading

-Transparent shell, does not affect luminescence.-Easy to remove and install

-Suitable for:For Toyota Camry 2007 2008 2009

-Note: Before purchasing, please make sure this item fits your vehicle.

Methods for disassembling and assembling lampshades

1. Remove the entire headlight (some models require removal of the grille and bumper). If the headlight cannot be removed, it is not recommended to do it yourself

2. Check the area around the headlights to see if there are screws fixed. If there are, remove the screws first

3. Prepare a hot air gun (high-power hair dryer is also acceptable), a flat screwdriver, and aim the gun at the pointed corner of the headlight to blow

4. Pay attention to the distance between the air vents, control the time, and avoid blowing the lamp body. After 3-5 minutes of slight heat, quickly remove it with force

5. Use a flat screwdriver to press against it, pry open a hole, and continue to blow soft sealant along the edge with a hot air gun

6. Blow and peel open at the same time, and it will all peel open in a short while. (The lampshade and interior decorative frame are connected together)

7. Use a screwdriver to clean the old glue, and clean it thoroughly. Remove the snake glue and tear off the oil paper

8. Remove the decorative silver frame from the old lampshade (don’t forget) and install it onto the new lampshade

9. The hot air gun evenly blows heat to soften the new snake glue, blowing a few more times to slow down the blowing speed. Softening snake glue

10. Observe the specific location of the glue on the old lampshade, and make a rough mark on the same position of the new lampshade

11. Apply force evenly to close the old lampshade, making sure it is evenly pressed all around, all corners, and the depth of pressure should be even

12. Press to the previously marked depth and observe if the depth of the lampshade is evenly pressed around it

13. Use clamps to clamp the lampshade and lamp body, wait for cooling, and avoid bouncing open

14. If the depth of the lampshade pressing is uneven, it is easy to cause gaps when installing the lamp in the later stage

15. Wait for 2 hours, prepare for loading, adjust the gap evenly to the original vehicle level

16. Due to the age of old models, many fasteners (such as screws and buckles) have sheet metal and plastic parts that will age and shrink. There may be very few cases where the gap is too large, which is a normal situation. For reasons other than the size of the lampshade (lampshade mold production, size ratio is one-to-one), the sheet metal technician can find a way to adjust the gap to the most appropriate position. If appropriate, re drilling and fixing screws can be done

Based on years of experience in selling lampshades, it is suggested that buyers should find a professional lamp changing shop to install them. Laotie, with guaranteed sealing in the later stage and strong hands-on ability, can explore and do things by itself when equipped. There are too many disassembly and assembly posts, which look simple and cumbersome to operate. If they can’t, they will not. Most repair shops will not install them, and they need to find a lamp changing shop to install them.